CLASSIFIEDS

Enderle Bug Catcher Set-Up $1995!!!
Magnesium Enderle "Bug Catcher" mechanical fuel injector set up for gasoline with hard lines, fuel block and clean idle barrel valve. Butterflies have been polished, then re-anodized red. Hat is polished magnesium. New polished 80A pump. Hat is absolutly gorgeous when just polished. No junk, serious inquiries only. Call Dean @ (702)336-7557

Two stock case 6-71 Blower set ups. Polished for BBC & SBC - $4500 Now Reduced to $3500 !!!

I have 2 ready to run, polished 6-71 blowers, both large lobe rotor units. One has hard anodized rotors as is the inside of the case. I have 2 BBC intake manifolds. One is a non-polished street unit with a thermostat housing outlet and the other is a polished competition unit with a remote thermostat housing (I do have a nice mounting bracket for the housing too). The other manifold is a polished SBC street unit that is new and never been bolted to a motor. I have (3) 57" and (2) 58.5" 3" wide 1/2" pitch drive belts, 3 or 4 blower pulleys (3" wide/1/2" pitch), 1 single carb plate and 2 dual carb plates (one is polished billet). I'm sure there is more stuff that I am forgetting about...All is in excellent condition. Call Dean @ (702)336-7557

1982 Ed Weddle 215" R.E.D. Dragster (Ex Maropoulos car) - A Steal @ $9995 !!!

Car has not been run since 1990 and needs chassis up-dates. Engine is a 331" SBC that dyno'd at 545 hp. Engine has approx 30 runs on it since new. Recommend new rings, bearings, valve springs, valve stem seals and all new seals/gaskets. Has 4 bolt main block w/splayed caps, steel crank, C&A rotating assembly, Milodon gear drive, Airflow Research aluminum heads, 850 Holley carb. I also have a brand new still in the box Scat billet crank for same engine. Trans is an A-1 powerglide (stock case) that has new clutches and steels. Torque converter is an 8" A-1 unit and stalls @6800 rpm. Ignition is MSD 7AL with crank trigger. Rear end is an 8 3/4" Chrysler with 4.56 gears in it. I also have a set of 5.13's and a brand new set of 4.89 gears too. Have 1 set of polished Centerlines and 1 brand new set of polished Convo-pro wheels, new inner tubes, new B&M shifter and neutral safety switch, new blue Holley fuel pump and I'm sure a bunch of other stuff that I am forgetting. Paint is very nice candy scarlet, magenta and pearl white. Graphics are vinyl and easily removed. This car is very consistant, goes straight and will hook in a mud slide. Car ran 8.50's @ 168 mph with the wrong gear and tire combo. Have an extra set of body side panels as well. This car would make an excellent "beginner" car as it did for me. Car has never been wrecked or hurt in anyway. Serious inquiries only. No junk here...Call Dean @ (702)336-7557


								*Parts, Accessories & More!*



		For Sale! '66-'67 El Camino door shells. No glass or hardware. Shells only. Excellent condition. $150.00 each. Contact Reid @ wildbunchcarclub@aol.com						Your Ad Here! Wanted!!! Passenger side quarter panel for 64-65 El Camino. Also right front fender for 64 Chevelle /El Camino...contact Reid @wildbunchcarclub@aol.com



		Enderle Bug Catcher Set-Up $1995!!! Magnesium Enderle "Bug Catcher" mechanical fuel injector set up for gasoline with hard lines, fuel block and clean idle barrel valve. Butterflies have been polished, then re-anodized red. Hat is polished magnesium. New polished 80A pump. Hat is absolutly gorgeous when just polished. No junk, serious inquiries only. Call Dean @ (702)336-7557 Two stock case 6-71 Blower set ups. Polished for BBC & SBC - $4500 Now Reduced to $3500 !!! I have 2 ready to run, polished 6-71 blowers, both large lobe rotor units. One has hard anodized rotors as is the inside of the case. I have 2 BBC intake manifolds. One is a non-polished street unit with a thermostat housing outlet and the other is a polished competition unit with a remote thermostat housing (I do have a nice mounting bracket for the housing too). The other manifold is a polished SBC street unit that is new and never been bolted to a motor. I have (3) 57" and (2) 58.5" 3" wide 1/2" pitch drive belts, 3 or 4 blower pulleys (3" wide/1/2" pitch), 1 single carb plate and 2 dual carb plates (one is polished billet). I'm sure there is more stuff that I am forgetting about...All is in excellent condition. Call Dean @ (702)336-7557 1982 Ed Weddle 215" R.E.D. Dragster (Ex Maropoulos car) - A Steal @ $9995 !!! Car has not been run since 1990 and needs chassis up-dates. Engine is a 331" SBC that dyno'd at 545 hp. Engine has approx 30 runs on it since new. Recommend new rings, bearings, valve springs, valve stem seals and all new seals/gaskets. Has 4 bolt main block w/splayed caps, steel crank, C&A rotating assembly, Milodon gear drive, Airflow Research aluminum heads, 850 Holley carb. I also have a brand new still in the box Scat billet crank for same engine. Trans is an A-1 powerglide (stock case) that has new clutches and steels. Torque converter is an 8" A-1 unit and stalls @6800 rpm. Ignition is MSD 7AL with crank trigger. Rear end is an 8 3/4" Chrysler with 4.56 gears in it. I also have a set of 5.13's and a brand new set of 4.89 gears too. Have 1 set of polished Centerlines and 1 brand new set of polished Convo-pro wheels, new inner tubes, new B&M shifter and neutral safety switch, new blue Holley fuel pump and I'm sure a bunch of other stuff that I am forgetting. Paint is very nice candy scarlet, magenta and pearl white. Graphics are vinyl and easily removed. This car is very consistant, goes straight and will hook in a mud slide. Car ran 8.50's @ 168 mph with the wrong gear and tire combo. Have an extra set of body side panels as well. This car would make an excellent "beginner" car as it did for me. Car has never been wrecked or hurt in anyway. Serious inquiries only. No junk here...Call Dean @ (702)336-7557






	Home \| About the Wild Bunch \| Club Rides \| Upcoming Events \| Club Photo Album \| Mooneyes Xmas Party 2008 \| Cruisin' for a Cure 2008 \| Related Links \| Ghosts of Van Nuys Blvd \| Newsletter \| Classifieds